Complementing the exceptional features of a 2110M,2110T transceiver the Codan 3160 Power Amplifier increases the output to 125 W across the full HF spectrum.
The output power can easily be changed between 125 W, 25 W or 5 W from the transceiver front panel.
BASE AND MOBILE APPLICATION
Packed into a small and rugged unit the 3160 is designed for installation fl exibility through its fl ange mount design and optional mounting bracket system.
RUGGED DESIGN
The 3160 Power Amplifi er meets or exceeds environmental specifi cation for shock, vibration, dust and immersion. It also provides complete protection against reverse polarity, over voltage, antenna mismatch and over temperature.
SYSTEM INTEGRATED
Specifically designed for the 2110M series transceiver, the Codan 3160 HF Power Amplifier is simple to confi gure and operate. When connected to a 2110M transceiver the 3160 is automatically detected at power on and ready to use.
In the event of PA failure the combined system will automatically bypass the PA block to ensure continued operation at 25 W. The Codan 3160 Military Power Amplifier’s operational status can be viewed on the 2110M,2110T front panel display.
VOICE AND DATA
The 3160 supports 100% duty cycle for normal speech or data operation.
ACCESSOREISS
Mounting Bracket
OPTIONS
100 W Output Power
Cooling Fan (recommended with Data)
SPECIFICATIONS
Frequency range
Transmit: 1.6 to 30 MHz
Power output
125/100 W PEP reducing with frequency to 95 W PEP at 30 MHz +/– 1 dB
CW or single tone: approximately 60% of PEP with average PEP control
(average control disabled on handset PTT)
Spurious and harmonic emissions
Better than 60 dB below PEP
Intermodulation
125/100 W: 26 dB below each tone 32 dB below PEP
RF input/output impedance
50 Ohm nominal
Duty cycle (100%)
Normal speech over full temperature range
All data modes up to maximum ambient temperature of 45°C (113°F) with Option F
Supply voltage
13.6 V DC nominal, negative earth
Normal operating range: 10.8 to 15 V
Reverse polarity protected
Overvoltage protection
Shuts down at 16 V DC nominal for duration of overvoltage
Supply current
Output power: 125 W or 100 W
Two-tone or CW: 9 to 17 A
Receive: 65 mA
Load protection
Safe under all load conditions
Environment
Ambient temperature: –30 to +50°C (–22 to 140°F)
Relative humidity: 95% non-condensing
MIL-STD-810F:
Power Amplifi er (PA) 268 mm W x 146 mm D x 77 mm H; 3.3 kg
11.3 in W x 5.7 in D x 3.0 in H
PA with Fan 65 mm W x 35 mm D x 130 mm H; 0.3 kg
11.3 in W x 5.7 in D x 4.1 in H
Weight
Power Amplifi er (PA) 2.2 kg (4.9 lb)
Fan 0.3 kg (0.7 lb)
PA Mounting Bracket 0.5 kg (1.1 lb)
Connector style
RF In: BNC
RF Out: 50-239 (LHHF)
PA DC Supply Control: 12 pin military
125 W OUTPUT POWER, 1.6 TO 30 MHZ